How to Size a Bakery Water Chiller
To size a bakery water chiller, record the litres each mixer draws per batch, the fill times and which draws overlap. Measure incoming water temperature and give the target temperature at the mixer. Use the draw pattern to estimate delivery flow and usable storage, then check how much cooling the plant needs between draws.
How to size a bakery water chiller
- Identify the cooling duty. State whether the installation serves ingredient water, mixer jackets or both.
- Log the busiest production interval. Record batch volumes and the timing and duration of each draw.
- Measure incoming and required temperatures. Include the warmest incoming water expected and the target where it is used.
- Check storage, delivery and recovery. Give Reftech the draw schedule and available utilities so each part of the plant can be selected for its job.
Identify where the cooling is needed
Ingredient water goes into the dough. A jacket circuit takes heat out through the mixer jacket. Both can be used on the same production line. Record the target temperature and flow for each circuit and include the mixer's requirements if the equipment maker has provided them.
Record the busiest mixer interval
A shift total can hide a short period when two mixers fill at once. Ask the operator to note when the water valve opens for each batch, how long that fill lasts and when the next batch starts.
| Record | Why it matters |
|---|---|
| Litres per draw and time per fill | Sets the delivery volume and flow during each fill. |
| Batch starts for each mixer | Shows when calls for water overlap or repeat. |
| Warmest incoming and target delivery temperatures | Defines the temperature drop needed. |
| Existing tank, pump and pipe route | Shows which components and connections can be assessed for reuse. |
Illustrative example. Two mixers each take 100 litres over the same 10 minutes. The pumps and pipes must deliver 200 litres in that interval, an average of 20 L/min. Observe the actual fill pattern if it varies during those ten minutes. Give the engineer the time until the next draw so they can check available tank volume and recovery.
How do I calculate the cooling capacity of a chiller?
For a steady flow of plain water, multiply flow in cubic metres per hour by the temperature drop in degrees Celsius and by approximately 1.16. The result is the rate of heat removal from the water in kilowatts. The multiplier uses a water density near 1,000 kg/m³ and a specific heat near 4.18 kJ/kg·K. Heat transfer reference
Illustrative example. Cooling 1 m³/h of plain water from 25°C to 5°C takes about 23.2 kW on the water side. For a batch process, check the draw and recovery schedule as well. Provide glycol concentration where applicable and the operating conditions used for the chiller selection. Pumps and pipework need their own design flow and pressure. Pumping system reference
Agree the circuits and the scope of supply
A complete plant may include an air-cooled or water-cooled chiller, heat exchanger, insulated tank, pumps, pipework and controls. A plate heat exchanger can transfer heat from the ingredient-water circuit to a separate glycol circuit.
At Mrs. Bectors in Bhiwadi, Reftech supplied, installed, tested and commissioned an air-cooled glycol chiller, plate heat exchanger, separate pipe circuits and an insulated stainless-steel tank. The installation was specified for 1,200 L/h of process water at 2°C. Bhiwadi project and circuit diagram
If the mixer needs a preset number of litres, discuss that dose and fill time with the supply temperature and pressure. That lets the team check the meter and valve at the mixer alongside the chilled-water supply. Automatic bakery water dosing
Talk through your bakery cooling needs
You can start with the cooling problem or the change you have in mind. Reftech can help you work out how the plant needs to serve the mixers. If you already have batch records, water temperatures, photos or a chiller nameplate, those are welcome. We can arrange a complimentary site visit if it helps define the installation.
Compare bakery chilled-water plants · Discuss your bakery cooling project